I am the proud owner of a CB2000. Well I actually have two. One is the earlier model handmade from acrylic rings and rods and the other one is the current injection moulded device. While I had a lot of breakages with the acrylic one you can drop the poly carbonate A-ring on the tiled bathroom floor without a problem.
Besides the known pulling out problem I found another way to cheat. The last two rings form a triangular opening that is just wide enough to allow the insertion of my little finger past the first joint. I can move it a little and touch a very sensitive spot there. It is all I need... Therefore I epoxied 2 little plastic rod across this triangle. And now I'm safe.
I find the CB2000 very comfortable to wear. You can almost forget you have one until... Someone mentioned a pinching of the scrotum by the A-ring. I had the same experience. If the skin under the ring folds double it is an itching at first then a pinching and after some hours it get really painful until you shift the skin to remove the fold. The application of some drops of baby oil helps a lot. Everything glides smoothly no more pinching. But pulling out is now a lot easier.
I've tried several possibilities to cure the pulling out problem e.g. not91212.htm . None of them was really successful.
My last idea is the use of what the people at BME call a 'pubic' piercing, on the upper side of the penis near its base. I haven't got one (yet). So i tried to simulate it with a ring I clipped on this area or fixed there with a strip of adhesive plaster. See pictures below. I found the result quite promising. With the real piercing I could not pull out, I'm sure.
Comments welcome.
Chaste regards
Norbert
[ Back to Product Reviews Page ]
Page last updated 00-Aug-17 by: Altairboy@aol.com