Recently, someone asked about the chastity cuff available from
Leathermasters in San Jose,
California.
I own one of these, and purchased it from Leather Masters. The
cuff says "Valor -- Stainless Steel" on it. The penis tube has an
ID of 1 3/8" and a length along the top of 4"; along the bottom 3".
The cuff does have a hole for the cuff key's lock pin, on the other
side of where the keyhole is.
I cut a piece of bicycle tire inner tube about 4" long and slipped it over the hinge of the handcuff ... that relieves a lot of chafing inherent to the cuff.
I bought mine before they came out with the locking pin for a PA. I bought a bolt and a carbide-tip drill of the appropriate diameter and drilled holes through the penis tube, and with a smaller drill bit made a hole through the bolt. This innovation makes the cuff far more secure.
It can be worn without a supporting harness, but not for very long. I recommend a belt to attach to the cuff link, but a strap for below isn't needed. The design is too bulky to wear under any but the baggiest trousers. If I were to redesign it, I would use a tube with a smaller ID and give it a sharper curve -- sharp enough that it will meet the hinge end of the cuff and be welded there, too. That design would not need a bolt through the end.
It's a good toy for an SM scene, but not for long-term wear.
Page last updated 97-Sep-23 by: Altairboy@aol.com