Stainless Construction Company Chastity Cage
The Stainless "BirdCage"
This device is made from Stainless steel strip, 16 ga. (.062"), and
1/2" wide. It is two pieces that when locked together, will prevent
any erection, and make masturbation impossible. The two main components
are the cock ring, and the cage.
The ring is fitted around the penis, behind the balls, as is traditional
for a cock ring. The inside circumference of the ring is the same as the
outside circumference of your FLACCID penis - BEHIND the balls. Where
the metal of the ring comes together, it is bent at a 90 degree angle,
forming two 1/2" plates that have been drilled to accept a small
padlock. All edges and corners are nicely rounded off. When measuring,
you want to insure it's tight enough not to slip off when flaccid.
The second and main component of the device is the cock cage. Made out
of the same 1/2" wide stainless steel strip, there are three parts.
A ring which will slip easily over a completely FLACCID penis is formed
to make a circle, and the ends are welded together and ground perfectly
smooth. This ring of course will be smaller in diameter than the cock ring
described above.
There are two sections that have been formed in a "U" shape. One of them
has equal legs, is fitted over the penis ring. It's length should be
approximately ONE inch longer inside than your FLACCID penis. This will
leave some room for expansion, but not a full erection. The second piece
is also formed to a "U" shape, but one leg of the "U" is 3/4" longer
than the other leg.
There is a slot milled out of the 3/4" extension that will fit over the
1/2" tabs of the cock ring. The slot will be just larger than 1/8" x 1/2",
but no more than needed to fit over the tab. The "U" legs are welded to
the outside of the penis ring only, on the vertical joints, and ground
smooth with no sharp edges anywhere. One of the legs cover the welded
joint in the penis ring, so you cannot see any joint from the outside
of the cage. The inside depth of the finished cage is ONE inch
longer than your flaccid penis. There is a total of eight
weld joints - two on each of the four legs of the cage. The "U"
sections cross each other at 90 degrees and are NOT welded together.
To install the cage, put the cock ring on, with the 1/2" tabs on top,
pointing towards your navel. The cage then is slipped over your penis,
and the slot in the long tab on the cage is fitted over the tabs of
the cock ring. Snap the lock on, and you are now secured. You will be
able to urinate, but completely unable to have an erection, or have
sexual intercourse. Note the balls will be squeezed somewhat between
the penis cage ring, and the cock ring behind the balls.
As you start
to get an erection, the cock ring will trap the blood in your penis,
which will prolong the time it will take for your partial erection to
subside. You may need to experiment to find which position it is more
comfortable to wear, either pointing up, or down. A gaff or jock strap
may be needed to keep it from pointing straight out and causing an
embarrassing tent pole in your pants.
This is a side view. You will want
to insure that the top edges of the tabs on the cock ring are completely
rounded off to prevent them from digging into your groin.
Designed by Stainless Steel Construction Company, Byran, Texas
Description by: Chattel
[ BirdCage Advertisement ]
[ BirdCage Frequently Asked Questions ]
[ BirdCage Sizing and ordering blank ]
[ BirdCage Female Chastity Belt info ]
[ BirdCage Measuring tip ]
[ Back to male chastity page ]
Page last updated 99-Feb-24 by:
Altairboy@aol.com
|